JDM-65A 8X8 1:14 hydraulic dump truck model

Method of purchase https://item.taobao.com/item.htm?spm=a1z10.1-c.w10580218-13731409007.4.Ciwu5G&id=25732120688

Scale: 1:14
Dimensions: length 687, width 186, height 262.5 units MM
Weight: 8KG
Theoretical Load: 15KG
Loading total mass: 23KG
Remote control: WFLY 06X-A 2.4G

Transmission: The latest model intravenous planetary gearboxes, shape simulation. Compact, simulation zipper style shift. Torque, can shift on the go. A gear reduction ratio of second gear 1:64 1:16

Power: Magnetic high torque brushed 60T 540 motors, can replace the brushes. Found vehicle weight 30 pounds to climb the steep slope of 45 degrees
Front suspension: lever arm type suspension balance, increased front axle swings, improve performance by truck
Rear suspension: parabola little piece of lightweight steel, load better than the big flexibility so that each tire uniformity Ground
Drive axle: zinc alloy simulation shape design single reduction axle, differential lock remote control can improve dump truck through sex. Allen uses static binding site model sleeve structure, higher mounting accuracy
Steering: Dual-link steering system, steering mounted between the girders, position simulation, 17KG steering torque servo drive, with each of the links below, can form different steering angle is reduced steering resistance.

Hub: 10 hole heat vacuum tire rim structure, satin surface of the anode.
Tires: Specification 315/80 / R22.5 diameter 86.5MM. Width 22MM Deep trench patterns, improve grip
Shaft: First model with V-static point involute angle drive shaft, spline structure, large torque shape simulation, "I passed by the surging momentum."
Oil tank: 5 multi-stage cylinders, diameter 37MM, 115MM stroke Pressure 5MPA, connected to intravenous pump kit model, the theoretical thrust 400KG
Oil Pumps: 2814 brushless motor, rated pressure 3.5-5MPA, flow 0.42L / MIN. Small high volumetric efficiency. 40A Brushless ESC by the driver.
Front buckle: withholding structure, convenient to replace the battery. The new structure, opened the lock when the car shell automatically pops up.
Preparation of Frame: galvanized plate material can absorb electronic devices such as electric heat transfer, acoustic group issued improving efficiency in the use of electronic components.
Battery compartment length can be flexibly adjusted to adapt to different batterysize.
Fenders: aluminum front fender with NC machining, shape simulation, balanced and durable. Sha plate welding processing technology.
Oil tank: anodized satin appearance, can be installed inside the hydraulic oil. As real shape, make this car more beautiful.

Toolbox: black galvanized sheet welding, all kinds of simulation can be placed inside the gadget. Improve playability.
Taillight: static point model designed with explosion-proof network taillights. Free to install lights 3-5MMLED

Car: The European U-type structure, reducing the material discharge faster adhesion tailgate is dovetail hook structure.
Electronics: high-voltage power line frequency modulated tone 320A7.2-16.8V
Sound Group: 3 heavy sound can be replaced

Note: The remote control voltage 9.6V, primary lithium batteries or 12V car battery voltage 11.1V3S.
Procedure: First, open the remote control (remote control knobs and joystick to the right hand in the middle position), then the main vehicle in the power supply, wait for the acoustic signal to confirm completion of 4 rear operative (probably within 5S), if the operation is very early may cause the ESC to enter setup mode.